The manual describes the steps to set up Fusebox External Control on the SmartgridOne Controller.
When setting up this integration, permission is granted to Fusebox to control this battery.
| Device Type | Variants | Supported |
|---|---|---|
| Solar Inverters | All | ❌ |
| Storage Devices | ✅ | |
| EV Chargers | ❌ |
| Country | Supported |
|---|---|
| Belgium | ❌ |
| Netherlands | |
| Estonia | ✅ |
and make sure the to the SmartgridOne Controller.
In the settings, the grid power limits should be set correctly. Click Settings and check the highlighted setting in the image. If necessary, adjust the settings.
Fusebox will provide a username/device identifier and password for each new installation. This must be used when adding the external signal driver.
In the next page, you have the option to include/exclude devices for remote control. Ensure to mark all checkboxes of devices you'd like to include.
When using multiple batteries, they are aggregated into one (virtual) asset for Fusebox.
'Fusebox' is now set up on the SmartgridOne Controller.
If you want to change the interval between measurements to avoid granularity issues you can go in Settings > Advanced Settings and modify :