Alarms Defaults | SmartgridOne Documentation

Meteo Data Dependency: Both Performance Ratio (PR) and Uptime calculations require meteorological data (like irradiation). Depending on the data source and location, this data might have a delay of up to a day.
Fluctuations: PR values can fluctuate based on the accuracy of meteo data and specific daily weather conditions (e.g., rapidly changing cloud cover).

Warning

Default Alarm Philosophy The web portal comes with preconfigured alarms. Our experience shows that over-sensitive alarms can lead to users ignoring them, undermining their value. Therefore, our default settings prioritize generating alarms late rather than too early.

You are encouraged to adjust these settings based on your knowledge of specific installations to create stricter and more timely rules where appropriate.

This page gives an overview of the alarms which are configured by default.

Name	Type	Supervised signals	Supervised node types	Rules
No production data	No data	• Active production power	• Installation • Smart grid controller site • Inverter • Hybrid inverter • String	• All: lookback period from 9 hours ago to 0 hours ago, time window from 09:00 to 18:00
No energy storage data	No data	• Active storage power	• Installation • Smart grid controller site • Battery • Hybrid inverter	• All: lookback period from 24 hours ago to 0 hours ago
No charger data	No data	• Active charger power	• Installation • Smart grid controller site • EV charger • EV charger connector	• All: lookback period from 24 hours ago to 0 hours ago
No grid data	No data	• Active grid power	• Installation • Smart grid controller site • Wind Farm	• All: lookback period from 24 hours ago to 0 hours ago
No data	No data	• Active power (generic)	• Power meter • Switch board • Hybrid inverter	• All: lookback period from 24 hours ago to 0 hours ago
Production is zero	Low delta	• Produced energy	• Installation • Smart grid controller site • Inverter• Hybrid inverter• String

Warning

Note

Note