External SignalsMQTT
External Signal Onboarding Flow
Tip
Tip
The Onboarding guideline is meant for new integrations using the Eniris MQTT Protocol.
A drawback of the MQTT protocol is that there is no notification or data transfer when a new installation is added. Therefore it is recommended to include the following steps before fully integrating with the SmartgridOne Controller.
Setup
The following will be required to set up an onboarding flow
-
External API
- A public API is required
-
At least two endpoints
- Onboarding endpoint The onboarding endpoint can be used by the SmartgridOne Controller to send a signal indicating that the installation is ready to be controlled. Additional info may include contract numbers entered by users, installation address, device info
- Offboarding endpoint The offboarding endpoint can be used to indicate that the external control signal has been removed from the SmartgridOne Controller, and control is no longer possible.
- Status/healthcheck endpoint The healthcheck endpoint can be polled regularly by the SmartgridOne Controller to provide a status update of the devices, or the system as a whole.