DevicesPV hybrid and battery inverters

Dyness Inverters

Important

Currently, the integration is support upto a state of charge limit to 95%. This is because when the state of charge goes beyond 95%, the battery can stop listening to setpoints due to the actions of the battery management system. We are working on resolving this issue with Dyness and other partners.

Supported Devices

Device Type	Variants	Modbus TCP (Ethernet)	RS485	Curtailment
EC100	100kWh	✅	✅	✅
DH100F	71~100kWh
DH200F

DMEGC Inverters

Dysun Energy

For correct RS485 wiring: Follow the guidelines for RS485 wiring.
If the wiring shown in the table below is incorrect, please let us know.
There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.

Device	SmartgridOne Controller model OM1	SmartgridOne Controller model IG8	RS485-USB converter	RS485-Ethernet converter
COM6 terminal 1A	RS485 A	RS485_POS	RS485 A	TX+
Com6 terminal 1B	RS485 B	RS485_NEG	RS485 B	TX-
N/A	RS GND	GND	Not available	G

Dyness | SmartgridOne Documentation

Dyness Inverters

Important

Supported Devices

On this page

Wiring

Ethernet

RS485

RS485 Wiring

Configuration

DH100F

NOTE: RS485 Device Addresses